Part Number
Part Number:
NSN:
NIIN:
Item Name:
RESISTOR , VARIABLE , NON-WIRE WOUND
Definition:
ALL EXCEPT USA
CAGE Information
| Code | Company |
|---|---|
| 73138 | BI TECHNOLOGIES CORPORATION |
Federal Supply Class
Title
RESISTORS
Inclusions:
INCLUDES VARISTORS; RESISTIVE BALLAST TUBES; RHEOSTATS; RESISTOR NETWORKS; RESISTOR MOUNTING HARDWARE; THERMISTORS.
Exclusions:
EXCLUDES RESISTANCE WIRE.
Characteristics (Decoded)
| MRC | Requirements Statement | Clear Text Reply |
|---|---|---|
| AEHT | CENTER TO CENTER DISTANCE BETWEEN TERMINALS | 0.700 INCHES NOMINAL |
| AEHT | CENTER TO CENTER DISTANCE BETWEEN TERMINALS | 0.700 INCHES NOMINAL |
| APXH | TERMINAL LOCATION | LOWER ADJACENT SIDE TWO ROWS |
| AAPN | SECTION QUANTITY | 1 |
| CRSX | ACTUATOR TRAVEL CONTROL FEATURE | SPRING |
| CRFJ | TEMP COEFFICIENT OF RESISTANCE PER SECTION IN PPM PER DEG CELSIUS | -250.0/+25.0 SINGLE SECTION |
| CQGN | AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER | 200.0 SINGLE SECTION |
| TTQY | TERMINAL TYPE AND QUANTITY | 3 PIN |
| ABWV | SHAFT DIAMETER | 0.125 INCHES NOMINAL |
| AEDX | UNABLE TO DECODE | UNABLE TO DECODE |
| ABTB | MOUNTING HOLE DIAMETER | 0.086 INCHES MINIMUM |
| ABXF | SHAFT LENGTH | 0.050 INCHES NOMINAL |
| CQCM | CENTER TO CENTER DISTANCE BETWEEN CENTER TERMINAL AND OUTSIDE TERMINAL | 0.300 INCHES NOMINAL |
| CRSS | RESISTANCE TOLERANCE PER SECTION IN PERCENT | -10.0/+10.0 SINGLE SECTION |
| CSDH | AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | 125.0 SINGLE SECTION |
| AKPV | MOUNTING FACILITY QUANTITY | 2 |
| CQCK | ROTARY ACTUATOR TRAVEL IN ANGULAR DEG | 12600.0 NOMINAL |
| CRGD | POWER DISSIPATION RATING PER SECTION IN WATTS | 1.0 FREE AIR SINGLE SECTION |
| AEFD | ACTUATOR TYPE | SINGLE SHAFT |
| CSDL | STANDARD TAPER CURVE PER SECTION | A SINGLE SECTION |
| ABJT | TERMINAL LENGTH | 0.500 INCHES NOMINAL |
| CQCC | ELECTRICAL RESISTANCE PER SECTION | 20.000 KILOHMS SINGLE SECTION |
| AYQR | CENTER TO CENTER DISTANCE BETWEEN TERMINAL ROWS | 0.100 INCHES NOMINAL |
| AXGY | MOUNTING METHOD | UNTHREADED HOLE |